Signet PRO7-SW Wall mounted induction loop amplifier with OLED display

General Description

The Signet PRO7-SW is a constant current, class-D, wall-mounted induction loop amplifier that is ideal for use in small to medium size rooms up to a maximum of 500 square metres.

This professional amplifier features an intuitive OLED graphical user interface.

Features

500m² coverage
OLED graphical user interface
2 x XLR mic/line inputs (selectable)
Outreach connector allows up to 10 utility plates to be added
Anti-tamper lock function prevents unauthorised adjustment of system settings
Class-D output stage for maximum efficiency and very high output
Short circuit protection against loop faults for increased reliability
Fault relay & graphical display provide clear indication of operation and fault status
Designed and manufactured in the UK

Delivery Includes

1 PRO7-SW Wall mounted induction loop amplifier

Technical Data

Supply Voltage: 230V 50Hz
Power Consumption: 200W
Line In: Input impedance: 1k + or – input to ground, Sensitivity: -20dBU typical
Microphone: Input impedance: 1k + or – input to ground, Sensitivity: -42dBU typical, Phantom power for electret microphones: 12V selectable (on/off)
Outreach: Input impedance: >10k, Sensitivity: 0dBU typical.
Outreach power: 24V dc nom. available via outreach connector (100mA max.) Loop Type: True current mode, Loop output voltage: 14V, Loop drive current @ 1 ohm: 7.5A
Line Out: 775mV output
Fault Relay: Single pole double throw (SPDT): NC, Common, NO.
Metal Compensation: Up to 10dB / octave design counteracts frequency dependent absorption by metal in the installation
over a bandwidth of approximately 5kHz.
Maximum Coverage Area: 500m², i.e., rooms up to 22m x 22m
Loop impedance: 0.5 to 2 ohms
Frequency Response (-3dB): 100Hz to 5kHz; Distortion: Less than 1 % typical; Signal to Noise Ratio: Better than –65dB any input; AGC Range (3dB change in output voltage current): 10dB. AGC ratio: 20:1.
Sensitivity Level Controls: Line Input, Microphone, 12V Phantom, Outreach, Metal Comp, Loop Drive.
Display & Controls: LED display with 4 membrane control buttons
Connectors: Microphone: 3-way pluggable connector, Line In: 3-way connector, Loop: 2-way connector, Outreach 4-way pluggable connector, Line Out 3-way pluggable connector, Fault Relay 3-way pluggable connector, 230V ac connector
Dimensions: 298H x 308W x 74D mm
Weight: 3.35kg
Misc: Panel Construction: Mild steel zintec, 1mm thick, black powder coated, IP Rating: IP40; Operating Temp: 0°C to 40°C; Maximum Humidity: 95% non-condensing